high performance amplifier, 15 db gain, 5 - 200 mhz am - /amc - 134 fp - 8 v 4.00 c - 25 absolute maximum ratings 1 parameter absolute maximum max. input power + 15 dbm v bias + 17.0 v operating temperature - 55 c to +85c storage temperature - 65c to +125c 1. operation of this device above any one of these parameters may cause permanent damange. p in configuration pin # function pin # function 1 rf out 6 rf in 2 gnd 7 gnd 3 gnd 8 gnd 4 gnd 9 gnd 5 vbias 10 gnd features n +49 dbm typical midband third order intercept n +29 dbm typical midband 1 db compression n 4.8 db typical midband noise f igure description m/a - com?s am - 134 is a coupler feedback amplifier with high intercept and compression points. the use of coupl er feedback minimizes noise figure and current in a high intercept amplifier. this amplifier is packaged in a flatpack with flan ges. due to the internal power dissipation the thermal rise should be minimized. the ground plane on the pc board should be co nfigured to remove heat from under the package. am - 134 is ideally suited for use where a high intercept, high reliability ampli fier is required.
high performance amplifier, 15 db gain, 5 - 200 mhz am - /amc - 134 specifications subject to change without notice. n north america: tel. (800) 366 - 2266 n asia/pacific: tel.+ 81 - 44 - 844 - 8296 , fax + 81 - 44 - 844 - 8298 n europe: tel. +44 (1344) 869 595, fax+44 (1344) 300 020 visit www.macom.com for additional data sheets and product information. v 4.00 2 electrical specifications 2 t a = - 55c to +85c case temperature parameter test conditions frequency units min. typ. max. gain 50 mhz @ +25 c 50 mhz db 14.0 14.6 15.2 frequency response ? 5 - 200 mhz db ? ? 0.5 gain variation with temperature ? 5 - 200 mhz db - 1.0 ? +0.5 1 db compression output power 5 - 200 mhz dbm +23 ? ? noise figure ? 5 - 200 mhz db ? ? 7.0 reverse transmission ? 5 - 200 mhz db ? - 21 - 19 vswr ? 5 - 200 mhz ratio ? ? 2.5:1 output ip 2 two - tone inputs up to +10 dbm 5 - 200 mhz dbm +55 ? ? ? ? output ip 3 two - tone inputs up to +10 dbm 5 - 200 mhz 5 - 70 mhz dbm dbm +37 +42 ? ? ? ? vbias ? ? v 14.25 15 15.75 ibias vbias = +15.0 vdc ? ma ? 90 110 power dissipation @ +15v bias ? w ? 1.35 ? 2. all specifications apply when operated at +15 vdc, with 50 ohms source and load impedance. 3. heat sinking: operation at case temp erature above 95 c is not recommended. heat sinking adequate to dissipate 1.75w must be provided in use. typical performance curves intermodulation intercept gain vs. frequency 13.0 14.0 15.0 16.0 3 5 10 20 50 100 200 300 frequency (mhz) gain (db) +85c +25c -55c 58 60 62 64 66 3 5 10 20 50 100 200 300 frequency (mhz) intercept (dbm)ip2 42 44 46 48 50 intercept (dbm) ip3 ip2 ip3
high performance amplifier, 15 db gain, 5 - 200 mhz am - /amc - 134 specifications subject to change without notice. n north america: tel. (800) 366 - 2266 n asia/pacific: tel.+ 81 - 44 - 844 - 8296 , fax + 81 - 44 - 844 - 8298 n europe: tel. +44 (1344) 869 595, fax+44 (1344) 300 020 visit www.macom.com for additional data sheets and product information. v 4.00 typical performance curves noise figure and 1 db compression vswr vs. frequency 3 ordering information part number package am - 134 pin fp - 9 amc - 134 sma c - 25 1.00 1.25 1.50 1.75 2.00 3 5 10 20 50 100 200 300 frequency (mhz) vswr rf in rf out 4.0 4.5 5.0 5.5 3 5 10 20 50 100 200 300 frequency (mhz) noise figure (db) 26 27 28 29 output power (dbm) noise figure output power
|
